KEDA · HT800

High-Tack Mounting Adhesive

Mounting Adhesive for Interior Panels and Trims

KEDA High-Tack Mounting Adhesive is intended for non-structural interior fit-out work where initial holding is an important selection requirement. Discuss the materials and installation detail with KEDA to select an appropriate product and application method.

Request a Quote View Parameters

Product Values

Initial Grab

Interior Mounting

Panels & Trims

Non-Structural Use

Technical Parameters

Product technical parameters
Composition	Order-specific adhesive formulation
Curing Mechanism	Specify for selected formulation
Form	Paste adhesive
Initial Grab	Specify for selected formulation
Tensile / Shear Strength	Set by approved substrate and joint test

Application & Packaging

Application Areas

Bonding compatible decorative wall panels to prepared interior substrates.
Installing skirting boards and wall-mounted decorative trims.
Mounting non-structural finishing components where the materials and fixing design are suitable for adhesive bonding.

Suitable Substrates

Compatible panels, skirting boards, trims and prepared interior substrates.

Packaging

Pack format: Specified for the selected adhesive grade
Fill volume: Specified for the order
Carton quantity: Order-specific
Label options: Private label packaging on request

Usage Instructions

Check the assembly. Confirm the material pair, component dimensions and weight, permitted conditions and required supports.
Prepare the surfaces. Remove loose material and contamination. Surfaces should be sound, clean and dry unless the selected product expressly permits otherwise. Use only approved cleaners and primers.
Apply the specified pattern. Follow the confirmed bead layout and bond-line thickness. Do not substitute a full-surface coating for a specified bead application.
Position and support. Press the component into place within the stated working time. Use suitable temporary supports and retain any required permanent fixings.
Allow curing before loading. Follow the verified curing requirements for the site conditions. Surface skinning alone is not evidence that the bond can carry its intended load.

FAQ & Limitations

Can I install components without screws or clamps?

Not automatically. Follow the assessed fixing design and supplied instructions. High initial grab is not a blanket replacement for temporary support or permanent mechanical fixings.

How much weight can it hold?

No general load rating is assigned here. The actual materials, bond area, load direction, component geometry, curing conditions and service environment must be considered. A laboratory strength value is not, by itself, an installation load limit.

Can it replace a mirror adhesive?

Do not assume so. Mirror coatings and safety films require specific compatibility assessment and an appropriate fixing design.

Can it bond PVC panels or natural stone?

Provide the exact panel or stone specification, including surface films, coatings and treatments. Compatibility and any risk of surface changes must be assessed for the selected product and materials.

KEDA PRODUCT ENQUIRY

Discuss Your Mounting Application

Share your materials, application, performance requirements, preferred packaging and expected quantity. KEDA can propose a suitable product configuration for High-Tack Mounting Adhesive.

KEDA High-Tack Mounting Adhesive